Your VR300 is telling you that it cannot connect to the network you previously set up. Make sure that the VR300 can receive the Wi‑Fi signal from your router in its current position, and that your Wi‑Fi connection is switched on. (You can test this using another Wi‑Fi enabled device.)
If this is not sufficient, it is recommended to use the "three-finger salute" (firmly press the green start button and the opposite bumper side simultaneously for approx. 6 seconds) and then re-integrate the robot into the WLAN.
Do NOT use force to push on the start button. A light press is enough to activate it.
If this is not sufficient, it is recommended to use the "three-finger salute" (firmly press the green start button and the opposite bumper side simultaneously for approx. 6 seconds) and then re-integrate the robot into the WLAN.
Do NOT use force to push on the start button. A light press is enough to activate it.