Why does my VR300 go back to the base station when I just pressed the Spot Cleaning button?

Vorwerk International

May 23, 2019 22:39

You can't switch on spot cleaning while cleaning is in progress. During cleaning, the "Spot" button becomes the "Base" button; pressing it causes the VR300 to return to the base station. Before you can activate spot cleaning mode, you have to cancel the current cleaning program. Afterwards, press "Spot" followed by the green Start button to switch on spot cleaning mode.

Comments

0 comments

Article is closed for comments.

Articles in this section

The display on the VR300 robot vacuum cleaner is flashing red and the device won't clean any more. Why is this?
How much will it cost to repair my Kobold robot?
The display on the VR300 robot vacuum cleaner is flashing red and the device won't clean any more. Why is this?
Why does the display on the VR300 robot vacuum cleaner light up red?
Can Vorwerk customer advisors repair devices?
I want to send the VR300 out to vacuum, but it just beeps and the light display flashes. Why is that?
Why does the Wi-Fi light on my VR300 robot vacuum cleaner not turn on, even though I have Wi-Fi at home?
I pressed Spot on the device and then the green Start button, but the VR300 robot vacuum cleaner doesn't go anywhere! Why is that?
Why does my VR300 go back to the base station when I just pressed the Spot Cleaning button?
Why does the Base symbol not light up at all?